Support Knowledgebase
How do I find the printer's IP address?
To print out the IntelliBar's Network IP Address:
Push the print server test/reset switch button on the rear panel of the printer. The switch is located behind the pinhole opening below the three print server status LEDs. Use a straightened paper clip to push and immediately release the test/reset switch one time. NOTE: Do not hold the switch down. Doing so will cause the print server to perform a factory default reset.
Once the test/reset switch is actuated, a test page will print with the configuration details of the print server, including its IP, subnet mask and gateway addresses.
Detailed network setup instructions can be found in the IntelliBar Net100 Quick Setup Guide.